Memory problem. Main board or
|
Код ошибки |
Описание |
|
AP |
Toner being mixed |
|
C01 |
Memory problem. Main board or simulation 70 required |
|
C02 |
EEPROM or main board |
|
C21 |
Drive problem |
|
C30 |
Scan, motor, switch |
|
C40 |
Lens drive |
|
C61 |
Fuser problem. No heat or open circuit |
|
C63 |
Fuser thermistor open |
|
C64 |
Fuser thermistor open |
|
C72 |
Drum thermistor open. Blank lamps |
|
C73 |
Drum thermistor shorted |
|
C74 |
Developer thermistor |
|
C75 |
Drum unit switch problem or drum setup problem |
|
C76 |
Waste toner full, reset with simulation 78 |
|
J01 |
Feed jam |
|
J02 |
Drum or fuser area jam |
|
J03 |
Jam |
|
OF |
Drum & developer units must be replaced (entire process unit) |
|
OP |
Front door open |
|
PE/PF |
No paper or paper feed problem |
|
U1 |
Total counter |
|
Ub |
Old developer unit and new drum. Might be upset by replacing the fuse, or by turning the drum through one full revolution |
|
Uc |
New developer unit and old drum. On rear drum is a lock. Inside the opening is a white plastic that snaps down after the unit is installed. Remove this rear cover and snap the white plastic blocker back up |
|
UF |
Toner or developer not installed properly. Bad toner sensor |